BW Technologies MicroClip XT Spécifications télécharger pdf (Page 62)

GasAlertMicroClip XT

Maintenance

Note

Detectors that are configured for 1, 2, or 3 gases may

contain a dummy sensor in one of the four sensor locations.

3. Insert the new sensor(s). For sensor positioning, refer to

Figure 12.

Figure 12. Sensor Positioning

4. To complete the detector, refer to Reassembling the

detector.

Replacing the Oxygen Sensor

Note

Detectors that are configured for 1, 2, or 3 gases may contain a

dummy sensor in one of the four sensor locations.

1. Gently remove the circular rigidified flex PCB atop the

sensor from the metal sensor posts. Take care not to tear

the flex cable.

2. Note the placement of the PCB to ensure it is replaced

correctly. Remove the two screws on the PCB.

a Caution

Ensure no damage occurs to the battery.

3. Lift the PCB straight up. The oxygen sensor will stay in

the front shell. Remove the sensor.

4. On roughly the same spot on the front shell, place the

new sensor. Lower the PCB over the oxygen sensor.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 73 74

Pas de commentaire

BW Technologies MicroClip XT Spécifications Page 62