BW Technologies MicroClip XT Spécifications télécharger pdf (Page 54)

GasAlertMicroClip XT

Calibration

When a sufficient amount of gas has been detected (approxi-

mately 30 seconds after the gas has been applied), the detector

beeps once, flashes, and K remains lit while the detec-

tor completes the span (approximately 2 minutes).

Successful Span

If the sensors have spanned successfully, the detector beeps and the

calibration procedure continues.

Unsuccessful Span

If any sensors fail the span, the following screen displays. Refer to

Calibration Troubleshooting

Calibration Due Date

Note

If a sensor fails calibration, the next due date for that sensor

will not reset. Refer to Calibration Troubleshooting

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 73 74

Pas de commentaire

BW Technologies MicroClip XT Spécifications Page 54