BW Technologies MicroClip XT Manuel de l'opérateur télécharger pdf (Page 16)

GasAlertMicroClip XT

Operator’s Manual

To charge the battery, complete the following:

1. Deactivate the detector. Insert the charging

adapter plug into an AC outlet.

2. Connect the charging adapter to the detector

IR interface. Refer to the following illustration.

3. Allow the battery to charge for 2-3 hours.

4. To reach full battery capacity, allow the battery

to fully charge and discharge three times.

5. Charge the battery after each workday.

Maintenance

To maintain the detector in good operating condition, perform

the following basic maintenance as required.

• Calibrate, bump test, and inspect the detector on a

regular schedule.

• Maintain an operations log of all maintenance, bump

tests, calibrations, and alarm events.

• Clean the exterior with a soft damp cloth. Do not use

solvents, soaps, or polishes.

Replacing a Sensor or Sensor Filter

a Warning

To avoid personal injury, use only sensors specifically

designed for the detector.

Use proper ESD handling practices.

Caution

Ensure hands are clean or wear gloves before handling

components.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

BW Technologies MicroClip XT Manuel de l'opérateur Page 16