BW Technologies MicroClip XT Manuel télécharger pdf (Page 20)

GasAlertMicroClip

Operator’s Manual

1. Deactivate the detector. On a clean surface, place the

detector face down.

2. Remove the six machine screws from the rear shell.

Remove the back cover by lifting the top and the

bottom upwards simultaneously to prevent damaging

the charging pins.

Replacing the sensor filter

1. Note the placement of the PCB to ensure it is

replaced correctly. Remove the two screws on the

PCB. Remove the PCB carefully.

Caution

Ensure no damage occurs to the battery.

2. Remove the old sensor filter. It may be stuck to the

sensors.

3. Place the new sensor filter.

Note

When inserting a new sensor filter, ensure the black

gasket is facing the front shell.

4. To complete the detector, refer to Reassembling the

detector.

Item Description Item Description Item Description

1 Front shell 5 Rear shell 9 H

S sensor

2 LEL sensor 6 Machine screws (6) 10 O

sensor

3 PCB 7 Sealing rib 11 Sensor filter

4 PCB screws (2) 8 CO sensor

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

BW Technologies MicroClip XT Manuel Page 20