BW Technologies MicroClip XT Manuel télécharger pdf (Page 14)

GasAlertMicroClip

Operator’s Manual

Bump Test

Gas Cylinder Connection

1. Connect the calibration hose to the 0.5 l/min regulator on the gas cylinder.

For use with the MicroDock II, use a demand flow regulator.

NOTE: Cylinders that are used with a demand flow regulator must meet

the following maximum inlet pressure specifications:

- Disposable cylinders 0-1000 psig/70 bar

- Refillable cylinders 0-3000 psig/207 bar

To perform an automated bump check, refer to the MicroDock II User Manual.

2. Connect the calibration hose to the calibration cap.

3. Attach the calibration cap to the detector.

4. Apply gas. Verify the visual and audible alarms activate.

5. Close the regulator and remove the calibration cap from the detector.

NOTE: The detector will temporarily remain in alarm until the gas clears from

the sensors.

6. Disconnect the hose from the calibration cap and the regulator.

Gas Cylinder Guidelines (Bump Test)

Ɣ To ensure an accurate bump check, use a premium-grade gas. Use gases

approved by the National Institute of Standards and Technology.

Ɣ Do not use a gas cylinder that is past its expiration date.

Note

Only use the calibration

cap during calibration

and bump check.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Pas de commentaire

BW Technologies MicroClip XT Manuel Page 14