BW Technologies MicroClip XT Manuel d'utilisateur télécharger pdf (Page 40)

GasAlertMicroClip

User Manual

No Gas Detected

When the detector senses a sufficient amount of

gas concentration (approximately 30 seconds), the

audible alarm beeps once,

flashes, and K

remains lit while the detector completes the span

(approximately 2 minutes).

The LCD displays FAILURE if the detector does not detect

any gas within 2 minutes before proceeding with the

calibration procedure.

Note

Successful Span

The detector will not span a sensor if:

If the sensors have spanned successfully, the audible alarm

beeps before the calibration procedure continues.

•

You do not apply gas to the sensor.

•

The sensor fails to detect at least one-half of the

expected gas concentration in the first

30 seconds.

Unsuccessful Span

If the sensors fail the span, the LCD displays FAILURE

before proceeding with the calibration procedure.

•

The gas concentration drops below one-half of

the expected gas level during the 2 minute span.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 56 57

Pas de commentaire

BW Technologies MicroClip XT Manuel d'utilisateur Page 40