BW Technologies MicroClip XT Manuel d'utilisateur télécharger pdf (Page 20)

GasAlertMicroClip

User Manual

Note

The sensors are continuously tested while the

detector is activated.

Automatic Zero and O

Calibration (optional)

5. The sensors (H

S, CO, and LEL) are automatically

zeroed and the O

sensor is automatically

calibrated (unless it is disabled in the detector’s

options). The detector beeps twice to signal a

successful zero and span.

If only the automatic oxygen calibration is enabled on

the detector, the following screen appears.

Note

If ambient air is set to be measured 20.8% vol., the

automatic oxygen calibration screen displays 20.8

instead of 20.9.

Calibration Due Date (optional)

6. The LCD displays the number of days remaining

until the next calibration is due.

Note

If the

calibration interval is set to 0, then the

calibration due date start-up feature is bypassed.

If any sensor is past its calibration due date, the

detector displays CAL DUE todAY as the detector

beeps, flashes, and vibrates.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 56 57

Pas de commentaire

BW Technologies MicroClip XT Manuel d'utilisateur Page 20